- Inicio
- Preguntas más frecuentes
- PCB
- PCB
- PTH Killer – Some Common Plating Void Factors
PTH Killer – Some Common Plating Void Factors
PTH Killer – Some Common Plating Void Factors
You may know that the most serious problem of PTH is void at where copper should be plated on. But do you know why this is happening? The common factors could be on material, drilling process, or plating process.
1) Material: The CTE of material is not suitable for the plating process. Compare to leaded process in the old times, the recent lead free process is having higher CTE requirement of material. If the material was still suitable for only leaded process, it might lead to void when it applies to lead free process.
2) Drilling Process: After drilling process there will be remaining dust on the material. When the vacuuming machine doesn’t function well that dust is still in the hole, there might be having high chance of leading to void after plating process.
3) Plating Process: When the board enters the plating liquid, bubbles will occur in the hole. Although the plating machine will vibrate to shake off the bubbles, the bubbles may still exist due to not precise parameter or some other reasons. And the bubbles, of course, will lead to void after plating process just the same idea as drilling dust remaining.
You may know that the most serious problem of PTH is void at where copper should be plated on. But do you know why this is happening? The common factors could be on material, drilling process, or plating process.
1) Material: The CTE of material is not suitable for the plating process. Compare to leaded process in the old times, the recent lead free process is having higher CTE requirement of material. If the material was still suitable for only leaded process, it might lead to void when it applies to lead free process.
2) Drilling Process: After drilling process there will be remaining dust on the material. When the vacuuming machine doesn’t function well that dust is still in the hole, there might be having high chance of leading to void after plating process.
3) Plating Process: When the board enters the plating liquid, bubbles will occur in the hole. Although the plating machine will vibrate to shake off the bubbles, the bubbles may still exist due to not precise parameter or some other reasons. And the bubbles, of course, will lead to void after plating process just the same idea as drilling dust remaining.